#QFINDER NOT FINDING NAS FOR MAC#
#QFINDER NOT FINDING NAS INSTALL#
#QFINDER NOT FINDING NAS PRO#

#QFINDER NOT FINDING NAS PRO#

It takes just a few seconds for QNAP Qfinder Pro to find all of the QNAP devices on the network.

#QFINDER NOT FINDING NAS INSTALL#

When you download QNAP Qfinder Pro and install it you will be displayed with a simple IP scanner which will automatically scan your network to look for a new NAS device. This section of the review describes QNAP Qfinder Pro 6.5.0 and its use in configuring your NAS. Tom COMPNAME Default 6 11:13:28 AM 11:13:38 AM Block_allДЄgain, thanks for your time and for any help to solve this or know if my tentative solution is safe for general use.В« Closer Look at the QNAP TS-328 | QNAP QTS 4.3 Smart Start В» QNAP Qfinder Pro 6.5.0 Is this it, and how do I find 'Block_All' and add and exception? Note, I changed my Local Host / MAC so I wasn't posting it o How do I add a rule to allow the NAS and move it to the SEP Manager?ДЇinally, when I let the system run a few minutes longer, I do see these two pop up repeately (even when not running the QNAP Qfinder in my network logs, under rule 'Block_All'.

My question: I have nothing in the ntp logs when I run the scan.

Check which rule is blocking, add the IP in that rule and then move the rule to to in the sepm. How do I 'see' NAS without taking firewall down?

Summary: I added QNAP NAS to LAN and can't 'find' it because of Symantec Endpoint Protection Firewall.

Link: Symantec Endpoint Prot firewall can't find NAS

#QFINDER NOT FINDING NAS FOR MAC#

I could add folders, web addresses, and file types, but not IP for MAC addresses. Where can I set this rule? I did try SEP > Change Settings > Exceptions (change settings> Add Exception. My Question: My firewall setting doesn't allow me to set rules, it's just check boxes.Solution: I added a new firewall rule for all traffic on the specific MAC address and I'm good.Summary: I can't see NAS with SEP on, I can see NAS with SEP disabled.I searched the forum and found these other posts, which only lead me to more questions: Is is safe to change this default setting? What are the concerns with it? I'm suspicious when I'm the only one who found chaning this setting 'fixes' things. My concern with that is I'm a home user, not a firewall/network protection expert, and none of the other solutoins mentioned it. Tentative Solution: I was able to see the NAS if I went to: Network Threat Protection Settings > Firewall Tab > Change from 'Allow only applicaion traffic' to 'Allow IP Traffic'

I cleared the SEP Network Threat Protection (NTP) logs, ran the QNAP QFinder utility, and there were no action on the SEP NTP logs. I purchased a new QNAP TS-212-E and like two posts below, I cannot see it with SEP running in default (as-installed) configuration. My computers and NAS are all on a shared wifi router and the home network. I'm using the version provided to military members for home use / self managed.

Window 7 / Symantic Endpoint Protection 12.1.671.4971. Hellow, and thank you for any help you can provide

Qfinder not finding nas